FAA Proposes Expanded Titanium Screw Replacement on Falcon 7X

A proposed airworthiness directive would widen inspections and screw replacements across additional Dassault Falcon 7X airplanes.

Updated on Nov. 19, 2026 in Air Travel

FAA Proposes Expanded Titanium Screw Replacement on Falcon 7X

The Federal Aviation Administration issued a notice of proposed rulemaking for an airworthiness directive affecting certain Dassault Aviation Falcon 7X airplanes, scheduled for Federal Register publication on November 19, 2026. The proposal would expand applicability and screw-replacement locations after affected parts were found in additional areas and airplanes.

Why it matters

Affected titanium screws were found in other locations and on more airplanes after an earlier directive, AD 2024-14-09, was issued. The proposal targets failure of a screw in a critical location that could reduce the airplane's structural integrity.

The FAA estimates 52 U.S.-registry airplanes would be affected, with a maximum total cost of $21,774 per product and $1,132,248 for U.S. operators. Some or all costs may be covered under warranty, per the manufacturer.

The players

Federal Aviation Administration

The U.S. federal agency responsible for regulating civil aviation safety, including issuing airworthiness directives for aircraft.

Dassault Aviation

A French aerospace manufacturer that produces the Falcon business jet line, including the Falcon 7X.

The details

The proposal continues requirements of AD 2024-14-09 and revises applicability from AD 2022-02-10. It removes calendar-based compliance times, defining parts-replacement compliance only in flight cycles, and limits installation of affected parts under certain conditions.

Timeline

  1. February 6, 2026: EASA AD 2025-0228R1 was dated, forming the basis for the FAA proposal.

  2. November 19, 2026: Scheduled Federal Register publication of the proposed directive under Docket No. FAA-2026-13821.

Roadmap

The proposal extends AD 2024-14-09, which required replacement of certain titanium screws, after affected parts were found in more airplanes and locations. It shows how a single screw-inspection requirement can grow through successive directives as manufacturers and regulators track field findings.

Owners and operators of affected Falcon 7X airplanes could face replacement work and related costs, though the manufacturer says some or all may be covered under warranty. The proposed compliance deadlines would be set in flight cycles rather than calendar time.

The takeaway

Owners of Falcon 7X airplanes should track whether a final directive changes compliance deadlines and check warranty coverage for any required screw replacement.

What happens next

The FAA will consider written comments on the proposal before deciding whether to finalize the compliance times and installation limits.

Further reading

Explore more Air Travel coverage on aircraft safety directives and airline operations.

Source note: This article includes information reported by Avi-go.