Fraunhofer Unveils Three AM Software Tools

Fraunhofer IGD showed three additive manufacturing software technologies at Formnext 2026 in Frankfurt, Germany.

Updated on Nov. 18, 2026 in Semiconductors

Screen-print poster illustration of a metal part with a stepped staircase surface beside a smooth surface, representing additive manufacturing geometry refinement.
Fraunhofer IGD unveiled three additive manufacturing software tools at Formnext 2026 in Frankfurt, including RISTRA-AM, a GPU-based laser metal simulation package. AI Illustration. Upload story photo >

Fraunhofer IGD presented three software technologies for Additive Manufacturing at Formnext 2026, held November 17-20 in Frankfurt. The tools include RISTRA-AM, a GPU-based simulation package for laser-based metal additive manufacturing, alongside a unit-cell design tool and a Shape Dithering method.

Why it matters

Faster distortion simulation can shorten the design-and-test cycle for metal parts built by laser-based additive manufacturing. Shape Dithering targets staircase artefacts that affect surface quality in printed and sand-mould-cast components.

RISTRA-AM uses GPU-based computation and is reported to run simulations 10-100 times faster than established CPU-based methods. The source does not specify the hardware, part geometries, or CPU baselines used in those comparisons.

The players

Fraunhofer IGD

The Fraunhofer Institute for Computer Graphics Research IGD, headquartered in Darmstadt, Germany, is an applied research institute that develops visual computing and simulation technologies.

The details

The three developments were exhibited at the joint Fraunhofer Competence Field Additive Manufacturing stand in Hall 11.0, Booth D31. Shape Dithering, a patented geometric method, was demonstrated with Fraunhofer IGCV using a binder-jetted sand mould to produce a conventionally cast AlSi7Mg0.3 aluminium component.

Timeline

  1. November 17-20, 2026: Formnext 2026 trade show in Frankfurt, where the technologies were presented.

The Tech Race

RISTRA-AM applies GPU computing to distortion simulation for laser-based metal additive manufacturing, a shift away from CPU-bound workflows. The move parallels the broader push to make simulation fast enough to run inside iterative part-design loops.

Engineers working on metal additive manufacturing could use faster distortion simulation to iterate on part designs more quickly. Users of printed or sand-cast components may see fewer staircase artefacts if Shape Dithering is adopted.

The takeaway

Simulation speed is becoming a practical bottleneck in metal additive manufacturing, and GPU-based tools may shorten how long engineers wait between design changes. Teams evaluating these methods should compare results against their own part geometries and hardware.

Further reading

For related coverage of chip-level computing that underpins GPU-accelerated simulation, see the Semiconductors section.

Source note: This article includes information reported by Metal Additive Manufacturing.