TheDigital1 Builds ESP32-C5 RF Interference Detector
The open-source project scans Wi-Fi bands for abnormal signal patterns and works standalone or with Home Assistant.
Updated on Nov. 18, 2026 in Consumer Electronics

TheDigital1 has created an RF interference detector based on the Waveshare ESP32-C5-Touch-LCD-3.5 board that scans the 2.4 GHz and 5 GHz Wi-Fi bands for abnormal interference patterns. The project's firmware, source code, and build guide have been released on GitHub under GPL-3.0.
Why it matters
The device runs without a computer, smartphone, or network connection, giving users a low-cost way to monitor wireless interference in their environment. Its open-source release lets others inspect, modify, and build on the design.
The scanner samples at 80 million samples per second and analyzes data with a 1024-point FFT that divides the spectrum into 312.5 kHz bands. Detected interference is classified as wide band, narrow band, pulsed wide band, or frequency swept, and states are rated NORMAL, SUSPECT, or ALARM against a 60-second baseline.
The players
Waveshare
Waveshare is a Chinese electronics company that produces development boards and displays for makers and embedded engineers.
ESPARGOS ESP-SDR project
ESPARGOS is an open-source project that uses ESP32 Wi-Fi hardware as a low-cost software-defined radio for research and experimentation.
The details
The ESP32-C5 Wi-Fi receiver operates as a low-duty-cycle software-defined radio based on the ESPARGOS ESP-SDR project. The device saves detection state changes and waterfall data to a microSD card during alarms and sends alerts to Home Assistant via MQTT discovery through a USB-connected bridge program.
The Tech Race
The project builds on the ESPARGOS ESP-SDR approach of treating ESP32 Wi-Fi receivers as low-cost software-defined radios. It shows how inexpensive microcontroller hardware is being repurposed for spectrum monitoring tasks that once required dedicated laboratory instruments.
Home users can build the detector with a single board and microSD card to watch for Wi-Fi interference affecting their network. Because the firmware is GPL-3.0 licensed, hobbyists can modify it or connect it to Home Assistant without paying licensing fees.
The takeaway
Low-cost microcontrollers now handle spectrum analysis tasks that once required specialized equipment. Makers interested in wireless diagnostics can study the open firmware and adapt it for their own setups.
Further reading
Explore more Consumer Electronics coverage for related smart home and maker hardware news.
Source note: This article includes information reported by Electronics For You - Official Site ElectronicsForU.com.



