U-blox Launches ALMA-W1 Wireless Modules

The ALMA-W1 series, built on Nordic Semiconductor chips, targets lower standby power for battery-powered Wi-Fi devices.

Updated on Nov. 17, 2026 in Semiconductors

Bold flat-color editorial illustration of a green circuit module beside a coin cell battery and a small sensor puck, evoking low-power wireless hardware.
U-blox introduced its ALMA-W1 wireless module series, built on Nordic Semiconductor chips, to cut standby power drain in battery-powered Wi-Fi devices. AI Illustration. Upload story photo >

U-blox has introduced its ALMA-W1 series of wireless modules, and initial samples are available to select customers. The series is built around Nordic Semiconductor's nRF7120 and nRF7120E chips and supports Wi-Fi 6/6E, Bluetooth LE, Thread, and Zigbee in select versions.

Why it matters

The modules are aimed at the power draw of keeping a Wi-Fi connection active on battery-powered devices. Reducing that standby drain could matter for connected products that must run for long periods on limited battery capacity.

U-blox reports 8 µA Wi-Fi connected standby current at 5 GHz using DTIM10, a 20-fold reduction versus the prior generation, with receive current of 10.3 mA to 11.7 mA and maximum transmit current of 241 mA. These figures are manufacturer-reported, and independent verification is not described in the source.

The players

U-blox

U-blox is a Swiss company that designs positioning and wireless communication modules for embedded and IoT devices.

Nordic Semiconductor

Nordic Semiconductor is a Norwegian fabless chipmaker known for low-power wireless system-on-chip products used in Bluetooth LE and IoT devices.

The details

Wireless MCU versions include a 256-MHz Arm Cortex-M33 processor, a separate 256-MHz RISC-V coprocessor, and 1 MB of RAM, and can be programmed with Nordic's nRF Connect SDK. Network processor models use U-blox's u-connectXpress software, which is controlled through AT commands; the tri-band ALMA-W111 and ALMA-W116 add Nordic's Axon Neural Processing Unit.

Timeline

  1. Article on the ALMA-W1 series introduction published November 17, 2026.

  2. Initial samples are available to select customers at introduction.

The Tech Race

The ALMA-W1 extends Wi-Fi 6 and Wi-Fi 6E support into compact modules aimed at battery-powered devices, a segment where efficiency in standby mode has become a key differentiator. The launch reflects continued competition among module makers to pair established Wi-Fi standards with lower-power chip designs.

For developers of battery-powered connected products, the ALMA-W1 offers a way to keep Wi-Fi connections active with much lower standby current than prior generations, according to U-blox. Developers will need to weigh the external-antenna W1x1 versus built-in-antenna W1x6 variants and the software toolchain differences between the two chip families.

The takeaway

Lower standby current is the key figure to watch for battery-powered Wi-Fi devices, since it determines how long a device stays connected between uses. Independent measurements will show whether the manufacturer-reported figures hold in real designs.

Further reading

Explore more semiconductor news and analysis on Wisevoter.

Source note: This article includes information reported by All About Circuits.