ATEK MIDAS Launches RF Amplifiers for Signal Chains
The RF and microwave chip designer offers MMIC amplifiers aimed at systems needing sensitivity and linearity, and has set up ATEK America in North America.
Updated on Nov. 19, 2026 in Semiconductors

ATEK MIDAS, a designer of RF and microwave integrated circuits, is offering MMIC amplifiers for RF signal chains that require high sensitivity and linearity. The company has also established ATEK America to strengthen its presence in North America.
Why it matters
Amplifiers with strong linearity and low noise are central to radio, microwave and sensing systems where weak signals must be captured without distortion. A regional subsidiary in North America may ease sourcing and support for customers in the region.
The ATEK177P4 covers 2 to 20 GHz with 25 dB gain, a 2.3 dB noise figure and +45 dBm OIP2, while the ATEK181P3 low-noise amplifier covers 10 MHz to 10 GHz with 21 dB gain and +35 dBm OIP3. Independent measurements and pricing are not provided.
The players
ATEK MIDAS
ATEK MIDAS is a designer of RF and microwave integrated circuits that sells amplifiers and offers custom IC design and turnkey production services.
ATEK America
ATEK America is the North American subsidiary established by ATEK MIDAS to expand its regional presence.
The details
ATEK MIDAS has listed a range of amplifier and mixer-related parts, including the ATEK177P4, ATEK178P4, ATEK181P3, ATEK563P5 and ATEK569N5. The company also offers custom IC design, IP blocks, engineering prototypes and turnkey production services.
Timeline
No specific dates or timeframes for the product releases or the ATEK America launch are given in the source.
The Tech Race
The ATEK177P4 and ATEK178P4 illustrate the long-running trade-off in low-noise amplifier design, where the 2.3 dB noise figure of one part sits against the 4.5 dB noise figure and higher +60 dBm OIP2 of the other. Positioning against larger RF chip suppliers is not addressed in the source.
Engineers designing radar, test equipment or communications hardware may gain another option for amplifier stages that need low noise or high linearity. The source gives no pricing or lead times to indicate when these parts would reach end products.
The takeaway
For RF designers, the key question is whether a given amplifier's noise figure, gain and intercept point match the receiver or transmitter chain being built. Comparing datasheet figures against system requirements before selecting parts remains the practical step.
Further reading
For more on the chips behind these amplifiers, explore our Semiconductors coverage.
Source note: This article includes information reported by Everythingrf.



