Ceramic Sludge Bricks Gain Strength in Trials

Researchers found that mixing ceramic sludge into fired clay bricks at 30% improved compressive strength while meeting two sets of evaluated standards.

Updated on Nov. 18, 2026 in Materials Science

Isometric editorial illustration of stacked fired clay bricks beside a pile of pale grey sludge powder on a flat floor, depicting reuse of ceramic waste.
Researchers found that mixing ceramic sludge at 30% into fired clay bricks improved compressive strength while meeting two evaluated building standards. AI Illustration. Upload story photo >

Researchers mixed ceramic sludge into fired clay bricks at concentrations from 0% to 30% and fired them at 1050°C in a monitored furnace. The study reports that adding ceramic sludge improved compressive strength, with the 30% mix meeting the evaluated requirements of BS 3921:1985 and SIRIM ECO 023:2016.

Why it matters

Sludge disposal poses a significant challenge, and the research explores whether ceramic sludge can be reused as a raw material in brick production instead. The findings suggest a possible route for diverting waste from disposal while producing building material that meets evaluated standards.

The study tested six concentrations (0%, 1%, 5%, 10%, 20%, and 30%) in laboratory-fired bricks, with the 30% mix reaching 25 N/mm2 compressive strength against 15.22 N/mm2 for the control. Long-term durability and large-scale production results were not reported.

The details

Ceramic sludge was combined with fired clay at six concentrations and fired at 1050°C in a monitored furnace. Shrinkage of the 30% sludge brick remained below the specified limit, and the brick satisfied the evaluated requirements of both BS 3921:1985 and SIRIM ECO 023:2016.

Timeline

  1. Study published early as accepted peer-reviewed research on 18 November 2026.

Big Picture

The 30% ceramic sludge brick is evaluated against BS 3921:1985 and SIRIM ECO 023:2016, two established brick performance standards. The research positions ceramic sludge as a candidate additive measured against those same benchmarks.

For builders and manufacturers, the findings indicate that ceramic sludge may be a viable additive in fired clay bricks at 30% concentration under the evaluated standards. Readers involved in construction materials sourcing may see this as a potential route to reducing the cost and environmental burden of sludge disposal.

The takeaway

Reusing industrial sludge as a brick ingredient can improve strength while meeting established standards, offering one approach to reducing waste. Further durability and production testing would be needed before wider adoption.

Further reading

Explore more on Materials Science to see how waste materials are being tested for construction use.

Source note: This article includes information reported by Nature.