CharIN Publishes Multipoint Truck Charging Hub Specification

Deliverable D4.1 sets shared site layouts, power architectures and technical requirements for megawatt-scale truck charging hubs in Europe.

Updated on Nov. 13, 2026 in Electric Vehicles

Isometric editorial illustration of a row of modular power cabinets feeding charging cables toward a parked truck on a concrete hub yard.
CharIN and VTT Technical Research Centre of Finland published Deliverable D4.1, a shared specification for megawatt truck charging hubs developed under the EU-funded MACBETH project. AI Illustration. Upload story photo >

CharIN and VTT Technical Research Centre of Finland published Deliverable D4.1, a specification for multipoint megawatt-charging (MCS) truck hubs developed under the EU-funded MACBETH project. The document serves as a shared reference framework for site layouts, power architectures and technical requirements.

Why it matters

As electric trucking expands, charging hubs must coordinate many high-power connections on limited grid capacity. A common specification gives operators and suppliers a consistent basis for building interoperable sites across Europe.

The specification maps more than 40 ISO, IEC and EN standards and sets a charger uptime target above 97%. It flags four areas that existing standards do not fully address, and the uptime target has not yet been confirmed in field operation.

The players

CharIN (Charging Interface Initiative)

CharIN is an industry association that develops and promotes open charging interface standards, including the Combined Charging System used in Europe and North America.

VTT Technical Research Centre of Finland

VTT is a state-owned research and technology organization in Finland that conducts applied research across energy, digital and industrial technologies.

The details

Deliverable D4.1 describes two reference site layouts, the second adding a dedicated waiting area and buffer zone. It proposes a shared power cabinet that distributes power dynamically across charge points, alongside a modular multi-cabinet concept that adds capacity through independent units. Vehicle-to-charger communication is based on ISO 15118-20 with its MCS profile over a 10BASE-T1S physical layer, and site energy management can throttle output during power peaks.

Timeline

  1. • Deliverable D4.1 was published on November 13, 2026.

  2. • The MACBETH project is scheduled to end in January 2029.

Roadmap

The specification applies ISO 15118-20 and its MCS profile to multipoint truck charging hubs rather than passenger-car sites. It extends an existing vehicle-to-charger standard into the heavy-duty segment as Europe prepares its electric truck infrastructure.

Fleet operators planning electric truck deployments in Europe may see more standardized charging hub designs as this specification is adopted. Drivers of commercial electric trucks could benefit from higher reported uptime if the 97% target is achieved in practice.

The takeaway

Standardized multipoint charging designs could make electric truck hubs more reliable and easier to expand. Operators planning sites should watch how the MACBETH pilots in Belgium and Sweden perform against the published uptime target.

Further reading

Explore more on Electric Vehicles to see how charging infrastructure is evolving for fleets and commercial transport.

Source note: This article includes information reported by CHARGED Electric Vehicles Magazine.