Researchers Propose Binary Control Circuit for Reflecting Surfaces
A MOSFET-based design aims to keep intelligent reflecting surfaces working under the high power levels used in wireless power transfer.
Updated on Nov. 12, 2026 in Semiconductors

Researchers have proposed a MOSFET-based binary control circuit for intelligent reflecting surfaces operating at 2.4 GHz, reported as accepted research in Scientific Reports. The circuit is designed to withstand input power of up to 1.250 W per unit cell in the best-case design.
Why it matters
High induced currents can damage or saturate sensitive control elements in high-power wireless power transfer environments, which limits where reflecting surfaces can be used. The authors say the results provide a topology-level design foundation for extending these surfaces to high-power wireless power transfer scenarios.
The control circuit operates at 2.4 GHz and tolerates up to 1.250 W per unit cell in its best-case design, within a 0.965-1.250 W range across variants. Hardware performance has been shown only in simulation, and physical prototypes have not yet been tested.
The players
Scientific Reports
An open-access, peer-reviewed journal published by Nature Portfolio that covers research across the natural sciences.
The details
The circuit uses a back-to-back MOSFET switching topology with series and parallel capacitors to suppress impedance variations caused by device nonlinearity. Supercell-level beam steering was demonstrated through far-field simulations at six power levels, but the work has not been validated in hardware.
Timeline
November 12, 2026: Article published early as accepted research in Scientific Reports.
The Tech Race
Intelligent reflecting surfaces have been studied mainly for low-power communication links, and this work extends that research toward high-power wireless power transfer. The proposed circuit is a design-level step, and its practical value depends on the hardware validation still to come.
If the design is validated in hardware, it could let reflecting surfaces operate in high-power wireless charging settings where they currently risk damage. For now, the work is simulation-only and no commercial product or timeline has been announced.
The takeaway
Simulation results are a starting point, not proof of performance; the key test will be whether a physical prototype matches the modeled power tolerance. Watch for experimental follow-up before assuming the design works outside the lab.
Further reading
For more background on the chips that power circuits like this, see Semiconductors.
Source note: This article includes information reported by Nature.



