DMEGC Solar Launches Steel-Frame Solar Modules

The new PV module series uses a steel frame in place of aluminium to improve load ratings and rear-side light capture.

Updated on Nov. 11, 2026 in Energy

Wide view of a long row of dark solar panels with slim silver steel frames on a rack in an open field under warm low sunlight.
DMEGC Solar launched a new photovoltaic module series with a steel frame in place of aluminium, citing nearly double the tensile strength of standard alloys. AI Illustration. Upload story photo >

DMEGC Solar has launched a new series of photovoltaic modules built with a steel frame rather than the aluminium used in conventional designs. The company says the frame's tensile strength is nearly double that of standard aluminium alloys.

Why it matters

Steel frames combined with an S-shaped cross-section aim to reduce rear-side shading and raise bifaciality, which could improve energy output from solar installations. The design also addresses mechanical load requirements for snow and wind.

The steel frame's tensile strength is nearly double that of standard aluminium alloys, and the modules are rated to 6000Pa snow load and 5000Pa wind load when properly mounted. The company's 2,078 kWh/kWp/year generation and 0.6% revenue gain figures are projections that have not been independently verified.

The players

DMEGC Solar

DMEGC Solar is a solar module manufacturer that is launching the steel-frame product series.

The details

DMEGC Solar is using Zn-Al-Mg coated steel (ZAM) for the frame to resist corrosion. The company pairs the frame with new cell technologies and an anti-reflective coating on the back glass to increase light capture from the rear side.

Timeline

  1. Launch of the steel-frame PV module series was announced on November 11, 2026.

Roadmap

The steel frame departs from the aluminium framing used in conventional bifacial PV modules, which have dominated the industry's rear-side generation designs. Steel's coefficient of thermal expansion of 12 sits between aluminium's 23 and glass's 6.9, a difference that bears on how modules hold up under temperature cycling.

For installers and system owners, a steel frame changes the mounting and load-rating specifications to check against local snow and wind conditions. The projected output gains depend on bifacial installation geometry and would need to be confirmed against a specific site's design.

The takeaway

Buyers comparing solar modules should look beyond headline wattage to frame material, mechanical load ratings, and rear-side design. Manufacturer projections are worth checking against independent test data before making purchasing decisions.

Further reading

Explore more energy developments in solar and other generation technologies.

Source note: This article includes information reported by PV Tech.