Weapons Maker Seeks Open Detonation Permit Renewal

Tech Ord, a Clear Lake division of AMTEC, is asking South Dakota to renew its permit for open burning and open detonation of hazardous materials.

Updated on Nov. 22, 2026 in Industry

Isometric editorial illustration of a flat open burn pad with a row of steel drums and a thin plume of smoke, evoking a regulatory permit decision.
Tech Ord, a Clear Lake division of defense contractor AMTEC, is asking South Dakota to renew its permit for open burning and open detonation of hazardous materials. AI Illustration. Upload story photo >

Live Poll

Should South Dakota keep allowing open burning and detonation of hazardous materials near Clear Lake?

Tech Ord, a Clear Lake weapons-component division of AMTEC, has applied to South Dakota to renew a permit allowing open burning and open detonation of hazardous materials. The practice was banned in the U.S. more than three decades ago, and defense contractors were granted time to find alternatives, an exemption that remains in place.

Why it matters

The renewal would extend a practice the broader U.S. has phased out, and the outcome will depend on whether state regulators weigh the facility's environmental record against the economic role it plays locally. New federal EPA restrictions on open burn and open detonation had been anticipated but have stalled.

The draft permit, which outlines Tech Ord's environmental record and corrective actions for soil and ground water contamination, is open for public comment until Nov. 28. If approved, the renewal would run five years for a facility that has operated since 1987 and employs about 175 people.

The players

Tech Ord

A Clear Lake, South Dakota division of AMTEC that produces detonating and explosive components for the U.S. Department of Defense.

AMTEC

The parent company of Tech Ord, which operates weapons-component businesses serving defense customers.

The details

Open burn and open detonation involve burning and exploding hazardous materials in the open air, and state regulations govern weather and wind conditions for such operations and require community notifications. Tech Ord produces detonating and explosive components for the U.S. Department of Defense.

Timeline

  1. More than three decades ago: open burn and open detonation were banned in the U.S.

  2. 1987: Tech Ord operations began after the facility was constructed.

  3. Nov. 28: Public comment period on the permit renewal closes.

  4. End of the year: New EPA restrictions on open burn and open detonation had been anticipated.

Industry Landscape

The federal ban on open burn and open detonation has been in place for more than three decades, but defense contractors retain an exemption while they find alternatives. The pending EPA restrictions, which had been expected by year's end, would narrow that exemption if they take effect.

Residents near the Clear Lake facility will have a window through Nov. 28 to review Tech Ord's environmental record and corrective actions before the state decides on the renewal. If approved, the permit would govern open burning and detonation at the site for five years, affecting weather-dependent scheduling and community notifications.

The takeaway

Permit decisions on hazardous-material operations often hinge on public comment, so readers near affected sites can use the comment window to raise concerns about environmental records and corrective actions before the decision is made.

What happens next

The public comment period on the draft permit closes Nov. 28, after which state regulators will decide whether to approve the five-year renewal.

Further reading

For related coverage of plant operations and permitting, see Manufacturing news for South Dakota.

Source note: This article includes information reported by SDPB.

Live Poll

Should South Dakota keep allowing open burning and detonation of hazardous materials near Clear Lake?