Ohio Requires Crash Attenuators for Some Highway Work

State specifications mandate truck-mounted attenuators on certain multilane work zones following the fatal I-70 crash of an ODOT bridge inspector.

Updated on Nov. 16, 2026 in Trucks

Flat-color editorial illustration of a single gray truck-mounted crash attenuator on an empty highway across rolling farmland under overcast light.
The Ohio Department of Transportation now requires truck-mounted crash attenuators on certain multilane work zones after a bridge inspector was struck and killed on I-70 near Zanesville. AI Illustration. Upload story photo >

Ohio Department of Transportation construction specifications require a truck-mounted attenuator, an energy-absorbing device on a shadow vehicle, for certain contractor operations on multilane highways with speed limits of at least 45 mph. The requirement follows the death of ODOT bridge inspector Jennifer Donley, who was struck and killed in an I-70 construction zone near Zanesville on Nov. 9, and the Ohio State Highway Patrol is investigating her death.

Why it matters

The rules set when contractors must place crash-absorbing vehicles between traffic and workers, and when portable barriers or other positive protection can be used instead. Ohio residents who drive its interstates regularly encounter these work zones, and the specifications define the protection crews are expected to have in place.

Attenuators are required on multilane highways with speed limits of at least 45 mph, with snooper bridge inspections needing one device below 60 mph and two at 60 mph or higher. Separate work areas more than 700 feet apart each require their own attenuator, but the source does not say whether those thresholds applied at the Zanesville site.

The players

Ohio Department of Transportation (ODOT)

The state agency that sets construction specifications for Ohio highways and oversees contractor work zones, including bridge inspections.

Ohio State Highway Patrol

The state law enforcement agency responsible for highway safety that is investigating the death of bridge inspector Jennifer Donley.

The details

ODOT's specifications require contractors to use a truck-mounted attenuator when the traffic-control manual shows one as required or optional on a shadow vehicle, and portable or permanent barriers can substitute in some configurations. A truck-mounted attenuator cannot replace another form of positive protection where that protection is specifically required.

Timeline

  1. Nov. 9: ODOT bridge inspector Jennifer Donley is struck and killed in an I-70 construction zone near Zanesville.

Roadmap

Ohio's attenuator rules fall under the state's construction specifications and traffic-control manual, which set the protection standards contractors must follow on qualifying highways. The fatal Zanesville crash places those written standards under scrutiny as the state reviews how work zones on high-speed interstates are protected.

Drivers on Ohio interstates may encounter work zones where a shadow vehicle with an attenuator sits between traffic and crews, and should slow and follow posted lane closures. The specifications determine when that protection is required, which affects how close workers can be to moving traffic.

The takeaway

Ohio's written attenuator rules set minimum protection for highway crews, but they apply only where the qualifying speed, lane, and configuration conditions are met. Drivers should treat any Ohio work zone on a fast multilane highway as a place where protective equipment and barriers are expected to be in place.

Further reading

For more on the vehicles that protect highway crews, see Trucks coverage on Wisevoter.

Source note: This article includes information reported by Cleveland.