Modified 3D Printer Prints Living Bacteria Structures

University of Rochester researchers adapted a low-cost plastic printer to print bacterial materials that stay alive for weeks.

Updated on Nov. 13, 2026 in Life Sciences

Compact desktop 3D printer on a lab bench extruding a pale amber lattice of living bio-ink into a clear gel bath.
University of Rochester researchers adapted a $450 plastic 3D printer to print living bacterial structures more than 100 layers high, a far cheaper route than commercial bioprinters costing up to $100,000. AI Illustration. Upload story photo >

University of Rochester researchers modified a standard plastic 3D printer to print living bacterial materials. The modified DIY bioprinter was built for $450 and can print structures with more than 100 layers.

Why it matters

The approach offers a far cheaper route to bioprinting than commercial systems that can cost up to $100,000. The support gel could significantly advance research on biofilms, where microbes must stay alive over time.

Laboratory tests compared the new support gel against earlier methods, with microbial survival extended from about nine days to four or more weeks. The article does not address how the slurry performs with bacterial species beyond those tested.

The players

University of Rochester

A private research university in Rochester, New York, whose researchers led the development of the modified bioprinter.

Cornell University

A private Ivy League research university in Ithaca, New York, whose researchers collaborated on the bioprinting work.

The details

The team replaced the plastic filament extruder with a syringe pump that pushes out a bio-ink mixing living cells with a polymer solution, which hardens into a gel after printing. A support gel called a slurry holds the bio-ink in place while it solidifies, and the syringe can both extrude and retract, which prevents oozing at the edges of structures.

The Big Picture

Commercial 3D bioprinters, which can cost up to $100,000, have limited access for many labs, and this $450 modified plastic printer offers a lower-cost path into living-material printing. Earlier DIY bioprinters were restricted to structures of fewer than 20 layers, a limit this work pushes past to more than 100 layers.

Because the printer's build instructions are available on GitHub, researchers with modest budgets could potentially replicate the setup for their own bacterial and biofilm studies. The article does not indicate when the approach might reach commercial or clinical use.

The takeaway

Lower-cost tools can open bioprinting to labs that could never afford commercial equipment. Keeping microbes alive for weeks rather than days could make biofilm research far more practical.

Further reading

Explore more in Life Sciences for context on how living materials are being engineered.