RMIT Titanium Lattice Floats, Resists Seawater
Engineers at RMIT University in Melbourne have 3D-printed a hollow titanium lattice filled with polyurethane foam that stays buoyant.
Updated on Nov. 16, 2026 in Materials Science

Engineers at RMIT University have 3D-printed a titanium lattice of hollow, interconnected struts filled with polyurethane foam that is capable of floating. The material is 70% stronger than stainless steel or high-density polyethylene of similar overall density.
Why it matters
Conventional titanium is too dense to float, and open metallic lattices sink because water enters their interconnected spaces. The result suggests a corrosion-resistant, lightweight material that could support marine applications in Victoria and across Australia.
The lattice stayed buoyant for more than two months in freshwater and lost only 0.15% of its mass in a two-week natural seawater test. Its long-term performance in deep-sea conditions has yet to be measured.
The players
RMIT University
RMIT University is a public university based in Melbourne, Victoria, known for its engineering and materials research.
The details
The titanium is printed as hollow, interconnected struts, and only those struts are filled with polyurethane foam, allowing water to flow through the structure while it stays afloat. The buoyant structure remained afloat after cracking, connection-point failure and fracture of an entire lattice layer, and sank only after being severely crushed and compacted.
Timeline
The buoyancy of the material was tested in freshwater for more than two months.
A two-week natural seawater immersion test was conducted at a Melbourne port.
The Big Picture
The result extends RMIT University's additive-manufacturing research on metallic lattices into buoyancy, challenging the assumption that open metal lattices must sink. It points toward uses in marine engineering where titanium's corrosion resistance has previously been offset by its density.
If the lattice is scaled up and proven over longer periods, it could support lighter, corrosion-resistant marine components for vessels and buoys. Energy absorption, thermal management and vibration control uses are also possible, though none is yet commercially available.
The takeaway
Adding a lightweight foam to a 3D-printed metal lattice can make a material that would normally sink float while keeping its strength. Watch for longer-term marine testing before assuming the design is ready for use at sea.
Further reading
Explore more Materials Science research from across Victoria.
Source note: This article includes information reported by Advanced Science News.










