Voyager 1 Stops Sending Science Data
The 49-year-old probe still transmits a carrier signal but no longer returns instrument readings, and engineers have not identified the cause.
Updated on Nov. 21, 2026 in Space

NASA's Voyager 1 stopped sending science and engineering data to Earth on November 14, 2026, while still transmitting a carrier signal from about 16.1 billion miles away. The probe passed the one light-day distance milestone on November 18, and a ground antenna near Madrid received the signal on November 19.
Why it matters
Voyager 1 is one of the most distant human-made objects and has been returning data from interstellar space for decades, so the loss of its science returns ends a rare direct line to measurements beyond the Sun's influence. Because engineers have not identified the cause, the outage raises questions about how long the mission's remaining instruments can keep operating.
Voyager 1 runs two instruments, a magnetometer and a plasma wave instrument, after engineers turned off three devices this summer and replaced them with lower-power alternatives. Engineers have not identified the cause of the data outage, which they believe more likely sits in the onboard computer that packages instrument readings for transmission.
The players
NASA
The National Aeronautics and Space Administration is the U.S. federal agency that operates the Voyager missions and leads the effort to restore data from Voyager 1.
Jet Propulsion Laboratory
The Jet Propulsion Laboratory in Southern California manages the Voyager missions for NASA and hosted the mission's 50th-anniversary celebration.
The details
Voyager 1 normally loads data onto its radio carrier signal in packaged blocks called frames, and ground antennas must first find the start of each frame, a step called frame sync, before the data can be read. Commands sent from Earth take about two days to reach the probe and two days for a reply, and in 2023 a similar carrier-only episode was traced to a problem in an onboard computer.
Timeline
2023: Voyager 1 sent a carrier signal with no data due to an onboard computer problem.
October 2026: Mission control lost contact with Voyager 1 for about 48 hours before it reconnected on its own.
November 14, 2026: Voyager 1 stopped sending science and engineering data.
November 18, 2026: Voyager 1 passed the one light-day distance milestone.
November 19, 2026: A ground antenna near Madrid received the milestone signal.
Legacy Systems
The current outage follows the 2023 episode, in which Voyager 1 sent a carrier signal with no data because of a problem in an onboard computer, suggesting a recurring fault in the same data-handling hardware. Engineers are now working to determine whether the two events share a cause.
The outage means scientists receive no new measurements from Voyager 1 for now, though the probe's remaining instruments may continue returning data for another year. Each command from Earth takes about two days to reach the probe and two days for a reply, so any repair will proceed slowly.
The takeaway
Long-running spacecraft depend on careful power management and remote repair, and even small hardware faults can take weeks to diagnose across billions of miles. Watching how the Voyager team responds offers a clear view of how deep-space missions keep working as their hardware ages.
What happens next
Engineers are working to find the cause of the outage, and NASA expects power savings to keep Voyager 1's instruments running until at least the 50th launch anniversary next summer.
Further reading
Follow more deep-space coverage in the Space section.
Source note: This article includes information reported by Mashable.



